|
|
|
Model GP Beside the Press GP824 460 Volt (Feed Openings 8" x 24") Soundproofed Staggered Rotor: 3 knife (2 knives each row) slant open rotor design, heat treated open rotor design. Low rotor RPM 700, with a cutting circle 8" rotating end disc, Knives made of High Carbon High Chrome D2 Tool Steel.Cutting Chamber: steel bolted construction and improved tangential feed design. Bed Knives: 2 (2 knives each row) mounted 230 degrees opposed, knives made of high carbon high chrome D2 tool steel. Hopper: pelican type, hinge mounted no hand tools required to open hopper. With tamperproof safety interlocks. Screen: Mounted in swing down cradle, with safety interlock screen with 1/4" diameter holes. Motor: 3 PH - 60 HZ 1720RPM "T" Frame Motor Drive: "V" Belts (3 per set). Electrical: NEMA 12 panel with magnetic starter. Integral control panel with magnetic starter, 110 volt controls and fused lockout disconnect switch and with tamperproof safety interlock (OSHA and ANSI approved) Capacity: *with 1/4" dia hole screen, up to 540 lbs./hr Base: caster mounted, hard wheels two swivel and two straight.. Floor Plan: 20" x 32" D x 53" H (Feed tray height 43") Shipping Weight: Approximately 480 lbs. *Depends on size and shape of parts.
|
Send mail to CompanyWebmaster or mpgmike@dragonbbs.com with
questions or comments about info. Phone-800-440-9249
Fax-254-582-0402
|